![]() ![]() This option lets you configure whether to move the caret to the next line if you comment a line with a line comment Control+/. ![]() Move caret down after Comment with Line Comment action Increasing this number might negatively affect the editor performance. In such cases, you may want to decrease the left margin using this option.įorce soft wrap in documents with lines longer than n characters This means that if your code will be centered when formatted properly, but if there are long unwrapped lines, the text might go beyond the viewport while there is a large margin on the left. This option lets you adjust the left editor margin in the distraction-free and zen viewing modes.īy default, the editor text in these viewing modes is centered vertically and the text column width corresponds to the Hard wrap at option on the Editor | Code Style page of the IDE settings Control+Alt+S. You can select one of the following options: Use this option to see an indicator that shows the current font size and the option to revert it back to default while zooming your code in or out in the editor. When this option is selected, you can use the Unicode name abbreviations for special characters, such as control codes. Render special characters, such as control codes, using their Unicode name abbreviations You can change the default Paste above the caret line behavior, and select either Paste at the caret line that restores the old Copy / Paste behavior or Trim if pasted middle line that will remove the unnecessary spaces before and after the copied line if it is pasted in the middle of the line. When pasting a line copied with no selection With this action, you can avoid that selection. This option lets you override the default behavior of copying Control+C or cutting Control+X the whole current line when nothing is selected in the editor.ĭon't select the copied line after invoking the Copy action with no selectionīy default, when you use Control+C without selecting anything, the whole line gets copied. Use this section to configure additional options for the Clangd engine.ĭon't copy/cut the current line when invoking the Copy or Cut action with no selection You can disable the floating notification by clearing this checkbox.įor more information, see Reload CMake on changes in CMakeLists.txt. Use floating toolbar to notify that CMake project needs to be reloadedīy default, when you make changes in CMakeLists.txt, CLion shows a floating notification indicating that the project needs to be reloaded. If you clear this checkbox, the profiles will not be generated for presets, and the existing presets-based profiles will be deleted upon the next CMake reload or project reopening. When this option is enabled (default), CLion converts the detected presets into CMake profiles automatically. ![]() By default, CMake profiles are reloaded in parallel, but sometimes it may cause issues when reloading CMake. Select this option if you want CLion to reload CMake profiles one after another. Perform initial profile configuration when a project is opened for the first timeĬlear this checkbox if you prefer CLion not to automatically configure and show a default CMake profile when you open a project for the first time. Select this option to completely disable automatic reload of CMake projects including external changes. The default generator is Makefiles.ĭo not trigger CMake reload on external changes if auto-reload is disabled If you set this checkbox, the default generator will be Makefiles, and CLion will switch to CMake File API only if you specify a custom generator.įor older versions, CMake File API is used for the case of custom generator only regardless of this option's state. The problem is that now it passes -G Ninja option even though cmake.generator option is empty.Use legacy generator for CMake 3.20 and higherįor CMake version 3.20 and higher, CLion uses CMake file API with Ninja generator by default. After recent VSCode update to 1.68.0 and CMake tools extension to v1.11.25 my configuration step stopped working. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |